Lincoln Electric IM584-D manual K1548-1 Linc NET Receptacle KIT Input and Output

C-8 ACCESSORIES C-8

K1548-1 LINC NET RECEPTACLE KIT (INPUT AND OUTPUT)

LINC NET RECEPTACLE (OUTPUT)

Optional Output Connector Installation into the Control Box Cabinet and/or into the Feeder Head Enclosure.

Control Box Cabinet Procedure

1.Turn off power.

2.Remove the screws from the front of the lower and middle option panels of the User

Interface cabinet.

3.Tilt the option panels away from the front opening of the Control Box cabinet. If the option panel has an electrical connector, disconnect it from the main printed circuit board (note connection point for re-connection later). Remove the option panel and set aside.

4.Remove the plastic plug (black) from the left hole in the bottom of the Control Box cabinet and store it in the bottom of the Control Box cabinet for future use, should the Optional Output Connector be removed.

5.Place the Optional Output Connector (Amphenol) through the hole opened by the previous step (place from the inside, out). Rotate the Optional Output Connector so itʼs aligning key is positioned to the front of the Control Box cabinet. Fasten the Optional Output Connector to the bottom wall of the Control Box cabinet with the four screws pro- vided.

6.Secure the choke (large circular component of the Optional Output Connector) by inserting itʼs leads into the white nylon clip located near the Optional Output Connector on the back wall of the Control Box cabinet. Insert the choke leads only.

7.The Optional Output Connector has two internal connectors, a four pin, and a single lead connec- tor. Connect the four pin connector to the unused four pin connector on the main printed circuit board. Connect the single lead connector to a similar connector found on a lead nearby that branches out of the Control Box wiring harness.

8.Re-install the lower and middle option panels by reversing the removal process. While re-installing the option panels, ensure clearance between Optional Output Connector components, Control Box wiring harness, and option panel harness (if any).

Feeder Head Enclosure Procedure

1.Turn power off.

2.Remove the Feeder Head rear access door. The Feeder Head cover can be removed to aid instal- lation, but is not required.

3.Remove the plastic plug (black) from the hole at the right rear of the Feeder Head and store it in the left side of the Feeder Head rear compart- ment for future use, should the Optional Output Connector be removed.

4.Disconnect a printed circuit board connector located at the bottom right corner of the printed circuit board and position it to the left so as to pro- vide clear access to the lower right corner of the Feeder Head enclosure.

5.Place the Optional Output Connector (Amphenol) through the hole opened by the two previous steps (place from the inside, out). Rotate the Optional Output Connector so itʼs aligning key is positioned to the top of the Feeder Head enclo- sure. Fasten the Optional Output Connector to the back wall of the Control Box cabinet with the four screws provided.

6.Secure the choke (large circular component of the Optional Output Connector) by inserting itʼs leads into the white nylon clip located near the Optional Output Connector on the floor of the Feeder Head. Insert the long choke leads rather than the short leads that run between the choke and the Output Connector. Insert the choke leads only.

7.The Optional Output Connector has two internal connectors, a four pin, and a single lead connec- tor. Connect the four pin connector to the unused four pin connector on the printed circuit board. Connect the single lead connector to a similar connector found on a lead nearby that branches out of the Feeder Head wiring harness.

8.Reconnect the printed circuit board connector that was disconnected earlier.

9.Replace the rear access door and Feeder Head cover if removed.

POWER FEED 10