Return to Section TOC
Return to Master TOC
| OPERATION | |
| CONTROLS AND SETTINGS |
|
| The welder/generator controls are located on the | the case front. Welding output terminals and ground |
| Output Control Panel of the machine case front. Diesel | stud are located on the machine right side, under the |
| engine idler control and start/stop controls are also on | door. See Figure B.1 and the explanations that follow. |
FIGURE B.1 – OUTPUT CONTROLS
Return to Section TOC
Return to Master TOC
1 
2 
3 | 5 |
4 | 6 |
|
7 |
1.CURRENT RANGE SELECTOR
2.FINE CURRENT ADJUSTMENT
3.230 VOLT RECEPTACLE
4.115 VOLT RECEPTACLE
5.WELD OUTPUT TERMINAL
6.WELD OUTPUT TERMINAL (+)
7.GROUND STUD
TOC
TOC
WELDER/GENERATOR CONTROLS
Return to Master
Return to Master TOC
See Figure B.1 for the location of the following fea- tures:
1.CURRENT RANGE SELECTOR: Selects continu- ous current output for constant current stick or TIG applications and constant voltage wire feed applica- tions. The amperages on the dial correspond to the average amperages needed for specific Lincoln welder rods. See Control of Welding Current for more information.
2.FINE CURRENT ADJUSTMENT: Allows fine adjustment of current within the selected output range. See Control of Welding Current for more information.
3.230 VOLT DUPLEX RECEPTACLE: Connection point for supplying 230 volt power to operate one or two electrical devices.
4.115 VOLT DUPLEX RECEPTACLE: Connection point for supplying 115 volt power to operate one or two electrical devices.
5.WELD OUTPUT TERMINAL
6.WELD OUTPUT TERMINAL (+) WITH FLANGE NUT: Provides the connection point for either the electrode holder or the work cable.
7.GROUND STUD: Provides a connection point for connecting the machine case to earth ground for the safest grounding procedure.
