Section TOC

Master TOC

F-48

TROUBLESHOOTING AND REPAIR

F-48

 

 

 

FAN BLADE/MOTOR REPLACEMENT (Continued)

PROCEDURE

Return to

Return to Section TOC

Return to

Return to Master TOC

1.Using a 3/8” nutdriver, remove the lower right side of the case wraparound cover.

2.Perform the Output Capacitor Bank

Removal Procedure.

3.Using a 5/16” nutdriver, remove the four fan mounting screws from the rear of the machine. See Figure F.22.

4.Using an open end 11/32” wrench, remove the two fan motor mounting nuts and lock- washers. See Figure F.22.

5.Using a flathead screwdriver, loosen the fan blade mounting band. See Figure F.22.

6.Pry the fan blade off of the mounting shaft. NOTE: If fan blade cracks or breaks

upon removal, replace it.

7.Carefully manuver the fan motor and fan blade out of the right side of the machine.

8.Replace the fan motor and fan blade if nec- essary.

9.Tighten the fan blade mounting band.

10.Carefully manuver the fan assembly into its original position.

11.Replace the two 11/32” fan motor mounting nuts and lockwashers.

12.Replace the four 5/16” fan assembly mount- ing screws in the rear of the machine.

NOTE: Make sure the fan blade is free to rotate when all of the mounting bolts are replaced.

13.Perform the Output Capacitor Bank

Replacement Procedure.

14.Replace the lower right case cover.

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

FIGURE F.22. - FAN MOUNTING BOLTS

REAR

Fan

Blade

Fan

Motor

}

 

}

Fan

 

 

Mounting

 

Band

 

11/32"

 

Mounting

 

Nuts

5/16" Bolts

POWER MIG 200

Page 82
Image 82
Lincoln Electric SVM157-A service manual FAN BLADE/MOTOR Replacement, Perform the Output Capacitor Bank Removal Procedure