Dual-Mode Internet Telephony Kit

3.When the handset is placed on the charger, I do not hear a beep.

If you have turned off the handset tone (refer to “Chapter 4: Using the Dual-Mode Internet Telephony Kit) or if the handset was previously powered off, then this is normal, and you were not supposed to hear a beep.

If you were supposed to hear a beep, then do the following:

A.Remove the handset from the charger, and then place it on the charger again.

B.Clean the charging contacts with a clean and dry cloth.

4.The Battery Empty icon is displayed even though the handset has charged for more than 14 hours. Do the following:

A.Check that the batteries are installed correctly.

B.Make sure the handset is placed properly on the charger.

C.Use new rechargeable batteries.

5.The handset’s display screen is blank. Do the following:

A.Check to see if the batteries are positioned properly in the battery compartment.

B.Make sure that you have properly connected the handset, charger, and base station. (Refer to “Chapter 3: Getting Started.”)

C.Put the handset on the charger to recharge the batteries.

6.The audio quality is poor. Do the following:

A.Move the handset closer to the base station.

B.There may be interference from nearby electrical devices. Move the base station as needed.

C.If the base station and handset are in a room with thick walls, move the base station and handset as needed.

68

Appendix A: Troubleshooting

 

Common Problems and Solutions

Page 76
Image 76
Linksys CIT400 manual Handset’s display screen is blank. Do the following