Linksys E3000
Frame Burst Enabling this option should provide your network with greater performance, depending on the manufacturer of your wireless products.. To use the Frame Burst option, keep the default, Enabled..
Authentication Type The default is Auto, which allows either Open System or Shared Key authentication to be used.. With Open System authentication, the sender and the recipient do NOT use a WEP key for authentication.. With Shared Key authentication, the sender and recipient use a WEP key for authentication..
Basic Rate The Basic Rate setting is not actually one rate of transmission but a series of rates at which the Router can transmit.. (The Basic Rate is not the actual rate of data transmission.. If you want to specify the Router’s rate of data transmission, configure the Transmission Rate setting..) The Router will advertise its Basic Rate to the other wireless devices in your network, so they know which rates will be used.. The Router will also advertise that it will automatically select the best rate for transmission.. The default setting is Default, for transmission at all standard wireless rates
Transmission Rate The rate of data transmission should be set depending on the speed of your wireless network.. You can select from a range of transmission speeds, or you can select Auto to have the Router automatically use the fastest possible data rate and enable the
N Transmission Rate The rate of data transmission should be set depending on the speed of your
Transmission Power Select the appropriate level of transmission power: High, Medium, or Low.. In most cases, keep the default, High..
CTS Protection Mode The Router automatically uses CTS
Chapter 3: Advanced Configuration
Beacon Interval A beacon is a packet broadcast by the Router to synchronize the wireless network.. Enter a value between 20 and 1000 milliseconds.. The Beacon Interval value indicates the frequency interval of the beacon.. The default value is 100..
DTIM Interval This value, between 3 and 255, indicates the interval of the Delivery Traffic Indication Message (DTIM).. A DTIM field is a countdown field informing clients of the next window for listening to broadcast and multicast messages.. When the Router has buffered broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM Interval value.. Its clients hear the beacons and awaken to receive the broadcast and multicast messages.. The default value is 3..
Fragmentation Threshold This value specifies the maximum size for a packet before data is fragmented into multiple packets.. If you experience a high packet error rate, you may slightly increase the Fragmentation Threshold.. Setting the Fragmentation Threshold too low may result in poor network performance.. Only minor reduction of the default value is recommended.. In most cases, it should remain at its default value of 2346..
RTS Threshold Should you encounter inconsistent data flow, only minor reduction of the default value, 2347, is recommended.. If a network packet is smaller than the preset RTS threshold size, the RTS/CTS mechanism will not be enabled.. The Router sends Request to Send (RTS) frames to a particular receiving station and negotiates the sending of a data frame.. After receiving an RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge the right to begin transmission.. The RTS Threshold value should remain at its default value of 2347..
Click Save Settings to apply your changes, or click Cancel Changes to clear your changes..
High Performance | 25 |
