
LR-42/44 Setup Instructions
5Select a Channel and/or Program Channel Selection Method
The Select button is used to change the channel. Press the button once to change the channel. The unit will either seek or scroll through the channels depending upon which channel selection method you have enabled. See below for description of possible channel selection methods.
5A Upon Power up
When set to factory defaults the unit will turn on to the last channel is was tuned to upon power up. However, the unit can be programmed to continuously seek for a channel with signal upon power up until one is found
5B Single Channel Systems
If you know what channel the unit will be used on, and you know that there is only one channel that the unit will need to be used on, you can lock it onto that channel now. See page 101 for channel lock information.
5C Multiple Channel Systems
In systems that require the receivers to be able to access more than one channel you must decide which type of channel selection method you want enabled. The default setting is that each time you press the Select button the unit will scroll to the next channel. If you want the receiver to automatically begin seeking for another channel when the signal is lost (such as walking from room to room in a museum) the
6Select Stereo/Mono Mode
If the receiver will be receiving a mono signal (stereo mode is not enabled on
7Setup Additional Programming (if desired)
Additional programming options, in addition to the
94