Wiring The 5100 Sharpener
DANGER 
THIS SHOULD BE DONE BY AN EXPERI-
ENCED, LICENSED ELECTRICIAN.
Wire the sharpener to a 20 amp, 220 volt breaker equipped with a disconnect. The elec- trical junction box is located in the upper center area inside the front panel.
IMPORTANT
Disconnect all power during routine mainte- nance and when the sharpener will be out of service for extended periods of time.
GROUND
LINE 110 VOLTS
LINE 110 VOLTS
|
|
| A |
| L1 | L2 | L3 |
6 7 8 E | N |
| E E 9 10 |
|
| ||
| T1 | T2 | T3 |
Electrical Wiring Source To Front
Panel Models
1.Unfasten the front panel on the control box and swing the door open.
2.Locate the disconnect. It is the black plastic switch located on the top center of the box.
3.Remove the screw A and slip off the cover.
4.Connect a 110V lead to the L1 position and a 110V lead to eh L3 position.
5.Connect the ground wire to the same position as the machine ground (the green/ yellow wire).
6.Replace the protective cover.
7.Close and secure the front panel.
10
