Locke RS-5100 manual Wobble Extensions, Spin Motor Brackets, Shaft Being Reversed -9 A

Now attach the drive coupler from the spin motor to the reel. In most cases, town wobble extensions work well. Figure 3-8

Wobble Extensions

Figure 3-8

Be sure the extension is as straight as possible. Ad- justing the spin motor on its bracket may be necessary. Good alignment eliminates drive line chatter. Figure 3- 9

Spin Motor Brackets

Figure 3-9

NOTE

The spin motor shaft must be removed and in- stalled on the opposite side of the drive unit for left drive reels. Do not turn drive assembly around on work table bars. (Fig 3-9A)

Once these steps have been completed, all mounting brackets on the reel unit and bases should be se- curely tightened. When grinding reels of the same make and model, subsequent units will be easier to place after the initial setup.

7.Close the rear canopy.

8.Open the front canopy.

9.A depth gauge is supplied to check that the reel’s center shaft is parallel with the wheel head travel. Loosen the screw in the alignment stem collar and slide the alignment stem for ward until it makes contact with the reel’s center shaft. Tighten the screw in the collar and remove depth gauge. Move carriage to opposite end of the reel and repeat instructions; taking notice of any dif- ferences, make adjustments accordingly. Figure 3-10

10.After checking the alignment, remove the depth gauge and close the front canopy.

11.Start the spin motor.

12.Adjust the dial on the RPM control to the proper speed setting for the diameter of the reel being ground. Refer to the chart located on the front panel for the proper setting. Figure 3-11

Shaft Being Reversed

Figure 3-9 A

15