Kernel halt error messages
Message | Description |
BAD Address = nn | Kernel memory is corrupt, hardware failure. |
Resetting to factory | A memory error is detected during a read |
defaults | from configuration memory. This also |
| indicates a hardware failure, but the system |
| may continue to initialize successfully. The |
| configuration from another Unit should be |
| saved to this Unit as soon as possible. |
Unit Halted | A major error has forced the kernel to stop |
| processing. The UltraMatrix waits to receive a |
| kernel or main firmware file from the bottom |
| board’s serial port using the serial |
| parameters: 9600, N, 8, 1. Connect the serial |
| cable supplied with the UltraMatrix as |
| described in the Serial Port section, start a |
| terminal emulator and transfer the file using |
| an ASCII file transfer protocol. |
Kernel is bad, load | The UltraMatrix waits to receive a kernel or |
new kernel through | main firmware file from the bottom board’s |
serial port. | serial port using the serial parameters: 9600, |
| N, 8, 1. Connect the serial cable supplied |
| with the UltraMatrix as described in the Serial |
| Port Section, start a terminal emulator and |
| transfer the file using an ASCII file transfer |
| protocol. |
Checksum error | The kernel writes this message at power up |
| when a memory error is detected during a |
| read from program memory. |
ULTRAMATRIX E-SERIES MANUAL
73
