Initial
Connecting to the mains supply
Select the mains cable suitable for use in your country. First of all, plug the mains cable plug into the power supply socket on the back of the unit and then plug the mains plug into a mains socket
Using the remote control for the first time
To insert or change the batteries, press on the arrow. While doing so, simply slide the battery compartment lid down and remove it. Insert alkali manganese batteries LR 03 (AAA) and ensure the correct position of + and
Adjusting the remote control for the system being used Depending on which system configuration you are operating, it is necessary to adjust the remote control to the appropriate mode.
Loewe TV set with | + |
|
Loewe TV set without | + | |
Factory settings
The button combination given must be kept pressed until the corresponding LED flashes twice (approx. 5 seconds).
Switching on/off
Set the remote control up for TV operation.
Press the on/off button on the remote control to switch on the Loewe TV set.
➠If the Loewe Sound Projector is operated in connection with a Loewe TV set with Chassis Digital+ HD100 (L2710) or Digital+ HD (L2700) with software from V4.x onwards, the Sound Projector will switch on or off automatically with the TV set.
When connected to a TV set without
Press the on/off button on the remote control.
➠When switched off, only the on/off button on the front of the Sound Projec- tor or on the remote control is active.
Acoustic room set-up
For the sound field of the Sound Projector to be aligned directly to your listening position, adjust the unit to your actual room. This is done using the microphone supplied and an automatic sequence controlled by the Sound Projector. The following steps are required:
A. Measuring the actual room.
B. Optimising the sound beams.
C. Optimising the sound (delay, volume, frequency, if applicable subwoofer).
You can save up to three sound
13 -