Everyday use

Playback

Selecting signal

You can play backsound from connected devices.

Press AUX (PIP) on the remote control several times

or on the unit press SOURCE several times to select the required signal source.

The name of the selected input signal source and the type of corresponding input mode are shown on the Sound Projector display.

Switch sound on/off

Sound off;

Sound on: Press button again or adjust volume V+.

Adjusting volume

V+/V– volume up / down

or on the unit press Vol -/Vol + .

The volume bar is shown briefly if no other menu is displayed.

Other sound settings for TV sets with RS-232C System Interface

As long as the volume bar or the selection of loudspeakers can still be seen in listening mode.

5Call up additional sound settings.

34Select sound settings.

6Change to the menu line below. 34Make changes.

You can also make additional sound settings on Loewe TV sets under the TV menu Sound.

Loading listening position

You can call upthe listening position that you saved previously (page 15, 18).

TV sets with RS-232C system interface

No further menu is shown.

34 Select.

 

Listening position

...

 

 

 

Position 1 (MEM1)

Position 2 (MEM2)

Position 3 (MEM3)

 

34Select one of the memory positions Position 1-3(MEM1-3) .

Confirm OK.

TV sets with an RS-232C system interface and swivel caster control

No further menu is shown.

34 Select.

Rotate TV (MEM2)

-20

34Select one of the memory positions Position 1-3(MEM1-3). These are marked on the bar.

Confirm OK.

19 -