Initial set-up

Sound components wizard

The auto setup is running. Please wait ...

During the measurement nobody should be present in the room.

After about 3 minutes a final chime is played. The procudure can be cancelled by the END key.

Example 2 - failed auto set-up:

Sound components wizard

Hint: The auto setup failed with Error E-1 (Too much noise).

Too much noise. Please restart the auto setup with the OK key.

END

Duringauto set-up, the listening room should be free of noise interference. Please leave the room during this time so that the sound beams can spread without disturbance.

Ifan error occurs during auto set-up, a warning will sound and a message will appear on the TV screen (page 26). If necessary, check the above described conditions for the Sound Projector to work perfectly.

Autoset-uptakes about 3 minutes and a final chime sounds when it finishes.

You can save three listening positions and call them up again, for example, to be able to take changing conditions in the listening room into consideration.

Position the microphone at least 1.8 m away from the Sound Projector centred on it on a level surface.

After auto set-up has been completed, a message will appear on the screen.

Example 1 - successful auto set-up:

Sound components wizard

With the OK key the position and the corresponding adjustments of the auto setup are stored to "Position 1 (MEM1)".

Sound components

 

Sound projector

END

Store settings

OK

OK Proceed

 

Sound projector

END

Start auto setup

OK

OK Proceed

 

If the message "Note: The auto set-up failed due to problem E-1 (room is too noisy)" is displayed , repeat the auto set-up process . Please also read the "Error messages for auto set-up" on page 26.

OK Apply results of auto set-up.

Remove the microphone from the Sound Projector now. The Sound Projector is now ready.

You will find information on operating the Sound Projector from page 19 onwards.

- 16