Initial set-up

After auto set-up has been completed, a message will appear on the screen.

Example 1 - successful auto set-up:

AUTO SETUP

MEASUREMENT COMPLETE

BEAM MODE : 5 BEAM

SUBWOOFER : NOT APPLICABLE

[OK] : Save set-up.

[END] : Do not save set-up.

Example 2 - failed auto set-up:

AUTO SETUP

MEASUREMENT COMPLETE

ENVIRONMENT CHECK [FAILED]

BEAM MODE : 5 BEAM

SUBWOOFER : NOT APPLICABLE

[OK] : Save set-up.

[END] : Do not save set-up.

If the message Error E-1is displayed, repeat the autoset-up process. Please also read the "Error messages for auto set-up" on page 26.

OK Apply results of auto set-up .

Remove the microphone from the Sound Projector now. The Sound Projector is now ready.

You will find information on operating the Sound Projector from page 19 onwards.

Saving sound set-up

You can save up to three sound set-ups. This allows you, for example, to take different listening positions, the actual room or TV positions into consideration when using a Loewe TV with swivel caster control. You can than call up these sound set-ups at any time.

Press the button for a long time. The menu MEMORY appears.

MEMORY

1) LOAD

2) SAVE

[] / [] : Up / Down

[OK] : Enter

56 Select the option SAVE.

Confirm OK.

2) MEMORY SAVE

MEMORY1

MEMORY2

MEMORY3

[] / [] : Select

[OK] : Enter

56 Select the option MEMORY1-3.

Confirm OK.

All settings you adjusted in the Sound Projector menus are permanently stored by saving.

- 18