Loewe R 37 Full-HD+ 100, R 37 HD+ 100 Managing stations, TV stations, 34Select Search wizard

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For example the description for TV stations. For radio stations the same applies, except that the radio menu is called in radio mode (see also page 34).

➠Station management is not possible if a programmed timer recording is still pending.

Search/update stations – Search wizard

In the search/update with the search wizard, new stations are searched for which are not yet stored.

➠You have to repeat the initial installation (see page 11) and automatically search for new ones if you want to delete all the existing stations and automatically search for new ones. Do also use the first installation if you want to change to receiving MHEG-5 stations (attend restrictions for DVB software update, see page 36).

Call TV menu.

34Select Settings,

6 go to the menu line below.

34Select Stations,

6go to the menu line below.

34Select Search wizard,

6go to the menu line below.

In the upper info text the current search settings will now be displayed:

Search wizard

Your TV carries out the update of the station range (search for new stations; delete stations no longer broadcast) with the following settings:

Location of TV set	United Kingdom
Signal source	DVB-T

TV menu
Settings
Stations		END
Search wizard
Change search settings	OK	Start search/update

If you want to change these search settings:

34Select Change search settings, OK wizard prompts search settings.

If you agree with these settings:

34Select Start search/update, OK start search.

Red button: Abort current search/update.

Explanations of some search settings:

Set location Select the country for country-specific defaults and station sorting.

Signal source Select antenna, cable, or satellite here, depending on where you want to search for new stations.

At this point you can also call a configuration of the DVB-T and DVB-S antennae via the green button (see page 12).

Antenna/cable: With selection of set location the conventional TV TV/colour standard/colour standard is the default. This should only standard be changed if stations with other standards are to be

searched.

Encrypted You can state whether coded stations are to be searched stations for in the search/update. Select yes then coded stations are also searched for. However, these stations can only be received in connection with a CA module and the ap- propriate Smart Card. Ask your dealer which Smart Card you need to receive certain stations. Handling of the CA

module is described on page 35.

DVB-TIf you want to run the station search independently of Search method the channel grid, select frequency search for the search

method.

DVB-CWith the selection of set location the conventional set- Settings tings will be preset. Only change this if you know other symbol rates and modulation types or if you have to specify the network ID for your cable network (informa-

tion available from your cable network provider).

If you want to run the station search independently of the channel grid, select frequency search for the search method.

DVB-SIf you want to run the station search independently of Settings the channel grid, select frequency search for the search

method.

The symbol rate is specified by the satellite provider and normally does not need to be adjusted.

- 24