Logitech Disassembly Instructions, MSZ-A09NA MSZ-A12NA MSZ-A15NA, Operating Procedure, Photos

9 DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below. There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism. The terminal without locking mechanism can be detached by pulling it out.

Check the shape of the terminal before detaching.

(1) Slide the sleeve and check if there is a locking lever or not.

Sleeve

Slide the sleeve.

Pull the terminal while

Locking lever pushing the locking lever.

(2)The terminal with this connector has the locking mechanism.

Hold the sleeve, and pull out the terminal slowly.

Connector

9-1. MSZ-A09NA MSZ-A12NA MSZ-A15NA	MSZ-A17NA MSY-A15NA MSY-A17NA
OPERATING PROCEDURE	PHOTOS
1. Removing the panel	Photo 1

(1)Remove the horizontal vane.

(2)Remove the screw caps of the panel. Remove the screws. (Photo 1)

(3)Hold the lower part of both ends on the panel and pull it slightly toward you, and then remove the panel by pushing it upward.

Photo 3
	Screws of the panel
Screw of the	Horizontal vane
conduit cover
Terminal block
cover
	Photo 2
Conduit cover
	Terminal block
	cover
	Conduit cover
MSZ-A09/12/15/17NA - 1	Screw of the
MSY-A15/17NA - 1	conduit cover
	Conduit plate
	MSZ-A09/12/15/17NA
	MSY-A15/17NA

25