Lopi Direct Vent Freestanding Stove owner manual Blower part #, Travis Industries, 1 0 0, 4 0 5

3 6 Optional Equipment (for qualified installers only)

Blower (part # 99000154)

WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to conducting service.

WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three- prong receptacle. Do not cut or remove the grounding prong from this plug.

1 Slide the thermodisk into the holder underneath the firebox.

Snap Disk Bracket

(attached to stove)

Snap Disk

2 Attach the blower following the directions below.

Attach the grommets (with spacers) to a the right side fan mounting bracket with

the included nuts and washers.

Slide the fan mounting plate into b the slot on each of the rubber

grommets.

Fan Mounting Bracket

(attached to stove)

Washer	Rubber Grommet
	(with spacer)

Nut

Blower Mounting Bracket

Slide the rubber grommets (with spacers inserted c inside) onto the fan mounting plate and attach

using the included washers and nuts.

11/32" Nutdriver

Travis Industries 1 0 0 - 0 1 1 4 2 4 0 5 0 1 1 4