Lopi Direct Vent Freestanding Stove Installation Addenda, ADDENDUM #2 Masonry Chimney, 1 0 0 - 0

Installation Addenda 4 1

ADDENDUM #2 Masonry Chimney

Interior Masonry Chimney

Conversions

• Follow the requirements and use

the equipment listed in the

illustration below to install this

appliance into an interior masonry

chimney.

The entire chimney system must be air-tight. Make sure to seal the flashing, clean-out, and thimble connection, and to inspect the chimney.

Make sure the coaxial pipe maintains a 1” clearance to any combustible. The vent must be sealed air-tight.

#991 High Wind

Termination

Flashing (included in

#934 Masonry

Conversion Kit

High-Temp

Silicone .

• Maximum vertical rise is 40'
•	Minimum vertical rise is 10'
•	See the chart on page 15 for
	determining the correct restrictor
	position.

#990 90° Elbow	4" Dia. Flex Line
	(UL 1777 Gas Liner)

Co-Axial Straight

Lengths

Connector with Cover

(included in #934 Masonry

Conversion Kit)

NOTE: these restrictor positions are based upon lab tests. The ideal restrictor position may vary slightly

Standard Masonry Fireplace

The entire chimney system must be air-tight. Seal the connector cover and inspect the chimney.

. -Temp HighSilicone

Make sure the coaxial pipe maintains a 1” clearance to any combustible. The vent must be sealed air-tight.

#991 High Wind

Termination

Flashing (included in

#934 Masonry

Conversion Kit)

4" Dia. Flex Line

(UL 1777 Gas Liner)

Connector (included in #934 Masonry Conversion Kit) secured and sealed to block-off plate

Travis Industries 1 0 0 - 0 1 1 4 2 4 0 5 0 1 1 4