Lopi Direct Vent Freestanding Stove Stone or Cast Inserts, Travis Industries, 1 0 0 - 0, 4 0

Optional Equipment (for qualified installers only) 3 9

Stone or Cast Inserts

WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to conducting service.

1Remove the stove top and place it upside down on a suitable non-scratching work surface (see the illustration on page 19). Remove the clips holding the cast inserts in place. Install the new inserts and secure using the clips – do not over-tighten and take care to not scratch the stone surface.

Place the stone inserts into the indents on the stove top. Attach with the clips and screws.

Phillips

Screwdriver

NOTE: slide the inserts inwards as far as possible to prevent them from striking the sides of the cast body.

2Two insert retainers hold the side inserts in place. On models shipped without side inserts, they are included in the owner's pack. If the side inserts are in place, loosen the screws on the insert retainers until they become loose (on some models they may be installed from behind). Remove the cast side inserts (if applicable). Slide the side inserts into place (take care to not scratch the surface). Replace the side insert retainers and tighten the screws until the side inserts become secure (do not over- tighten).

Insert Retainer (the retainer "bows" when it is tightened, securing the stone insert in place)

5/16" Nutdriver

Stone Insert

Travis Industries 1 0 0 - 0 1 1 4 2 4 0 5 0 1 1 4