Optional Equipment (for qualified installers only) 3 3
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1Remove the glass (see page 19). Remove the log set (if installed - page 21)
2Remove the burner (see illustration below).
Remove the two ember trays on each side of the |
|
burner. Reach into the firebox and lift the left side of |
|
the burner upwards and slide it to the left. | Ember Trays |
|
Do not lift the burner from the pins.
Make sure the mixing tube slides onto the orifice.
NOTE: the pilot hood may interfere with the burner during removal. You can remove the burner hood by pulling up on it until it detaches (see the illustration on the following page).
Burner Replacement:
Make sure this pin inserts into the hole in the bottom of the burner and theburner is fully seated.
Orifice
Mixing Tube
Slide the air shutters all the way to the right before installing the burner.
Travis Industries | 1 0 0 - 0 1 1 4 2 | 4 0 5 0 1 1 4 |