Lopi Direct Vent Freestanding Stove owner manual 4 0Installation Addenda, Travis Industries

4 0Installation Addenda

ADDENDUM #1 Class A Chimney Conversion Kit

Simpson Duravent provides a conversion kit for those wishing to use an existing wood stove chimney to vent this direct vent stove. The illustration below gives an overview of this type of installation. See the instructions included with the kit for details.

!Do not exceed the maximum vertical rise (see the section "Approved Vent Configurations" starting on page 12) allowable. Remember to set the restrictor position to the correct position (based upon the vertical rise height - see the chart on page 15).

!The conversion kit does not work on interior masonry chimneys.

Chimney Conversion Kit A (# 931)

Metalbestos 6" I.D. Security Chimneys 6" I.D. Jackes-Evans 6" I.D. Hart & Cooley 6" I.D. Pro-Jet 6" I.D.

Chimney Conversion Kit B (# 932)

Simpson Dura-Vent 6" I.D. Air-Jet 6" I.D.

Metal-Fab 6" and 7" I.D. Amer. Metals 6" & 7" I.D. Metalbestos 7" and 8" I.D. Jackes-Evans 7" and 8" I.D. Hart & Cooley 7" and 8" I.D. Pro-Jet 7" and 8" I.D. Security Chimneys 8" I.D.

Chimney Conversion Kit C (# 933)

Simpson Dura-Vent 7" and 8" I.D. American Metals 8" I.D.

Air-Jet 8" I.D. Metal-Fab 8" I.D. American Metals 8" I.D.

Each Kit Contains:

Retro Connector Retro Vertical Top

Additional Required Equipment:

4" Flex (#711 or U.L. 1777) Termination (#991) Co-Axial Sections

Screw the Retro	Retro Vertical Top
Vertical Top to the	(screw to chimney)
Flex Pipe

Cut the Flex Pipe to the chimney height plus 3" (75 mm)

Type A Chimney

4" (100 mm)

Aluminum Flex

Pipe

Retro Connector (screw to chimney)

	Screw the Retro
Simpson Duravent Direct	Connector to the
	Flex Pipe
Vent Pipe Sections
(use adjustable section)

Travis Industries 1 0 0 - 0 1 1 4 2 4 0 5 0 1 1 4