Table of Contents |
|
Section 1: Introduction | 3 |
Section 2: Installation | 5 |
Preparation | 5 |
Recommended Tools and supplies | 5 |
Mounting the Unit | 5 |
Connecting to a NMEA 2000 Network | 6 |
Network Nodes | 7 |
Adding a Network Node | 7 |
Additional Network Information | 8 |
Section 3: Operation | 9 |
Boat Setup | 9 |
Pages | 10 |
Engine Trim | 10 |
Diagnostics | 10 |
Fuel Manager | 10 |
GPS Position | 11 |
Single Analog | 11 |
Dual Analog | 11 |
Quad Analog | 11 |
Single Digital | 11 |
Dual Digital | 12 |
Quad Digital | 12 |
Synchronizer | 12 |
Trim Tabs | 12 |
Viewing options | 12 |
Basic Menu | 12 |
Adding Pages | 13 |
Removing Pages | 13 |
Page Scrolling | 14 |
14 | |
Screen | 15 |
Audio Setup | 16 |
System Setup | 17 |
Bus Devices | 17 |
To Reset Values: | 17 |
Section 4: EP Configuration & Calibration | 19 |
Temperature Sensors | 20 |
To Unconfigure a temp sensor: | 20 |
To Configure a temp sensor: | 20 |
To Reconfigure a temp sensor: | 20 |
Fuel Flow (Port, Center and Stbd) | 21 |
1
