1.From the Fuel Setup menu, select RST TRIP FUEL and press Enter, which will launch the following message: Press Enter to Reset Trip Fuel.
2.Press ENTER, which will take you back to the Fuel Setup menu. Press EXIT repeatedly to return to the main display.
System Setup Menu
To get to the System Setup menu, press MENU, then scroll down to System Setup and press ENTER. The System Setup menu contains: Engine Displayed, Bus Devices, Sonar Alarms, Eng/Tank Configuration, Reset Values, System Information and Change Units.
Engine Displayed
The Engine Displayed command allows you to monitor up to three engines on your vessel.
Basic menu with System Setup highlighted (left). System Setup menu
(right) with Engine Displayed selected.
1.After accessing the System Setup menu, highlight ENGINE DISPLAYED and press ENTER. A menu will appear with the following options: Port, Center and Starboard. This is important when viewing information like Fuel Management, RPM and Engine Voltage.
2.Select the engine you would like to monitor and press ENTER.
Bus Devices
1.To run a system check for devices connected to the NMEA 2000 network, choose BUS DEVICES from the System Setup menu and press ENTER. After a Searching for Bus Devices message comes up, a list of all devices attached to the LowranceNET — the Bus Devices list — will appear.
Sonar Alarms
1.If you would like to set Deep or Shallow Sonar Alarms, select SONAR ALARMS from the System Setup menu and press ENTER. An alarm menu will pop up with two choices: Shallow or Deep.
38
