3.3.3Command Line Update Tool for DOS
Using a DOS bootable floppy,users can use a FC Flash Utility called
MPTUtil to update LSI Logic adapters with new firmware Section( 3.2, “Download New FC Firmware,” page
Note: The MPTUtil program will not operate properly from a windows command window. It must be run from a DOS floppy.
Running the MPTUtil Program – Use the MPTUtil program to update the LSI Logic FC firmware on any 4 Gbit/s host adapter. Locate the MPTUtil.exe program and FC929X.ROM code on your distribution media, as well as the DOS4GW.exe file. Copy these files to a blank, formatted diskette. Label it “FC Firmware diskette.”
To update the firmware, complete the following steps:
Step 1. Ensure that the host adapter is properly installed in the system PCI slot.
Step 2. Insert the LSI Logic FC firmware diskette into drive A.
Step 3. Boot the system to the DOS prompt A:\>.
Step 4. Execute the MPTUtil program directly from the DOS command line by typing at the prompt:
A:\ MPTutil
The MPTUtil program identifies all LSI Logic host adapters in the system, and it allows you to select which adapter to update (Figure 3.4).
Figure 3.4 MPTUtil Device Selection
LSIMPTUTIL 1.00.00 |
|
| ||
| Vendor | Device |
|
|
Choice | ID | ID | Bus | Device |
1 | 1000h | 0626h | 0h | 28h LSI 929X Fibre Channel Host |
Adapter |
|
|
|
|
2 | Refresh |
|
|
|
Which chip (0 to quit)? __
Update the FC Firmware |
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.