Interrupt coalescing timeout selected is 100 (256 decimal) microseconds
Interrupt coalescing depth selected is 8 (8 decimal) Interrupt coalescing has been set
Change will take effect after system reset
Note: The system must be power cycled before the changes take effect. It is not sufficient to execute
4.7.6Set FC Link Speed
There are two modes of operation for FC: 1 Gbit/s and 2 Gbit/s. It is important to match the speed of the port with the speed of the loop or fabric to which the port is attached.
LSI Logic has implemented autonegotiation on the 2
Select the port or adapter shown (use the port name your system assigns):
ok select /pci@8,700000/IntraServer,fc@1
Then enter commands as shown in the following example:
ok show-link-speed
Link speed selected is 1 Gbaud
Current link speed is 1 Gbaud
ok set-link-speed
Note: The OpenBoot BIOS provides help when you enter a command that does contain the proper arguments. In this case, OpenBoot responds with:
usage is
ok a set-link-speed
Link speed selected is autobaud
Link speed has been set
Change will take effect after system power cycle
BIOS Features |
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.