Configuration
3-62 9124-A2-LB20-00
March 2000

Table 3-16. SNMP Traps and Trap Dial-Out Options (4 of 4)

Trap Disconnect
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether the COM port-connected modem disconnects after the SNMP trap
message has been sent. This configuration option only applies to modem connections
initiated as a result of sending the SNMP trap message.
Enable – Disconnects the call after sending an SNMP trap message(s).
Disable – Does not disconnect the call and holds the line until it is disconnected
manually or by the remote modem. This allows the NMS to poll the FrameSaver unit for
more information after receiving an SNMP trap.
Call Retry
Possible Settings: Enable, Disable
Default Setting: Disable
Controls whether an incomplete call (busy, no answer, etc.) is retried when an SNMP
trap message is sent to the COM port-connected external device.
If an Alternate Dial-Out Directory is specified, the alarm directory’s telephone number is
called first. If the call cannot be completed, then the alternate directory’s telephone
number is called (see the Control menu’s Modem Call Directories).
Enable – Attempts to retry the call, up to one time per SNMP trap message, with a
delay between the retry. The delay is specified by the Dial-Out Delay Time (Min)
configuration option.
Disable – Does not retry an incomplete call.
Dial-Out Delay TIme (Min)
Possible Settings: 1 – 10
Default Setting: 5
Specifies the amount of time between call retries when an SNMP trap message is sent;
the wait between call attempts (see Call Retry).
1 – 10 – Sets the number of minutes for the delay between call retry attempts
(inclusive).
Alternate Dial-Out Directory
Possible Settings: None, 1 – 5
Default Setting: None
Specifies whether an incomplete call (busy, or no answer, etc.) resulting from an attempt
to send an SNMP trap message is retried using an alternate telephone number. Up to
5 alternate call directories can be set up, but only one at a time can be used.
When Call Retry is enabled, the alarm directory’s telephone number is called first. If the
call cannot be completed after one additional try, then the specified alternate directory’s
telephone number is called.
None – Does not dial-out using one of the alternate directory telephone numbers.
1 – 5 – Specifies the call directory containing the telephone number to call if a call
cannot be completed using the telephone number in the alarm directory (Directory
Number A in the Control menu’s Modem Call Directories).