Lucent Technologies SLV 9124 3-64

Configuration

3-64 9124-A2-LB20-00

March 2000

Stop Bits

Possible Settings: 1, 2

Default Setting: 1

Determines the number of stop bits used for the COM port.

1 – Provides one stop bit.

2 – Provides two stop bits.

Ignore Control Leads

Possible Settings: Disable, DTR

Default Setting: Disable

Specifies whether DTR is used.

Disable – Treats control leads as standard operation.

DTR – Ignores DTR. This may be necessary when connecting to some PAD devices.

Possible Settings: Enable, Disable

Default Setting: Disable

Determines whether a user ID and password (referred to as the login) is required in

order to log on to the asynchronous terminal connected to the COM port.

Display Conditions – This option only appears when Port Use is set to Terminal.

Enable – Requires a login to access the menu-driven user interface.

Disable – Does not requires a login.

Port Access Level

Possible Settings: Level-1, Level-2, Level-3

Default Setting: Level-1

Specifies level of user access privilege for an asynchronous terminal connected to the

COM port. If a login is required for the port, the effective access level is determined by

the user’s access level. When a login is not required, the effective access level is

determined by this option.

NOTE: The effective access level is always the lowest one assigned to either the

port or the user. For example, if the Port Access Level assigned is Level-2,

but the User Access Level is Level-3, then only level-3 access will be

permitted for the port.

Display Conditions – This option only appears when Port Use is set to Terminal.

Level-1 – Allows full access and control of the device including monitoring, diagnostics,

and configuration. The user can add, change, and display configuration options, and

perform device testing.

CAUTION: Before changing the communication port’s access level to Level-2 or 3,

make sure that the Telnet Session Access Level is set top Level-1 and at

least one Login ID is set to Level-1. Otherwise, access will be lost. If this

occurs, you must reset the unit to the factory defaults and begin the

configuration process again.

Level-2 – Allows limited access and control of the device. The user can monitor and

perform diagnostics, display status and configuration option information.

Level-3 – Allows limited access with monitoring control only. The user can monitor and

display status and configuration screens only.