Connecting the DPA-1 | Lyngdorf Audio specification

Connecting the DPA-1

Connecting to sources and ampliﬁers

The DPA-1 is very simple to hook up.

1.Connect all sources to the DPA-1.

Then connect the DPA-1 output signal to a powerampliﬁer.

Source(s)

DPA-1Digital Pre-Amplifier

DPA-1

Poweramp

12

Image 12

Lyngdorf Audio owner manual Connecting the DPA-1, Connecting to sources and ampliﬁers

Contents

DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Front Panel Controls Display Indicators Rear PanelPage Remote Control Page Connecting the DPA-1 Connecting to sources and ampliﬁers Using Main and Line outputs Menu System Navigating the Menu System Menu Tree This is an overview of the entire DPA-1 menu structure Introduction to RoomPerfect Global ListeningFocus Listening Voicing Guided Setup RoomPerfect Setting the Measurement Volume Level Focus Measurement Room Measurements Adding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomKnowledge RoomCorrection Display Timeout Volume Disp. TimeoDisplay Disp. Brightness Volume Def. VolMax. Vol Input Name Input Sensitivity Advanced Setup Main Out Main Out ControlMain Out Level Line Out Routing Crossover Frequency Delay Filter Type Trigger Setup Remote ControlFactory Reset Firmware Versions RoomPerfect Troubleshooting Firmware Upgrading Connectors Cleaning and Maintenance Technical Speciﬁcations Audio Protection MainsTrigger Mechanical Technical Assistance Appendix Voicing Curves