Lyngdorf Audio DPA-1 owner manual Using Main and Line outputs

Using Main and Line outputs

As described in “Routing” and “Crossover Frequency” there are many ways to utilize the Main and Line out- puts. Here we have described the three most common set-up´s. Please note the products, outputs and cross- over frequencies are chosen randomly in these descriptions. Combine them at your own will and needs.

1.Single-amp set-up with no subwoofer.

A poweramp is connected to each Main Output Left and Right. No crossover is selected.

Main Output Left

No filter

Speaker

DPA-1Main Output Right

No filter

PowerampSpeaker

2.Poweramplifier and subwoofer set-up.

A poweramp is connected to the Main Out Left and Right and highpass crossover is set at 80Hz.

The Subwoofer is connected to the Line Output and lowpass crossover is set at 80Hz. Remember to set the subwoofer cut-off frequency to maximum.

Main Output Left + Right

Highpass filter set at 80Hz

SpeakersPoweramp

DPA-1Line Output Right

Mono lowpass filter set at 80Hz

Active subwoofer

3.Lyngdorf 2+2 setup.

A poweramp is connected to Line Output Left and Right and highpass crossover is set at 400Hz.

Two Lyngdorf boundary woofers are connected to Main Output Left and Right, through a poweramp, and lowpass crossover set at 400Hz.

Main Output Left + Right DPA-1

Highpass filter set at 400Hz

Line Output Left + Right Lowpass filter set at 400Hz

Speakers Poweramp Poweramp Boundary woofers

13