Volume, Def. Vol, Max. Vol | Lyngdorf Audio DPA-1 manual

Volume

The sub menus accessible in the Volume menu are:

Volume

Def. Volume

Max. Volume

Def. Vol.

The Default Volume setting controls the default volume at start-up and can be set from 0 to 99 dB. However, a setting over 88 is not recommended as this corresponds to max output with full scale digital input.

Max. Vol.

The Maximum Volume setting is a safety precaution used for limiting the maximum volume which can be achieved by spinning the wheel or increasing volume via the remote. This can be set to avoid excessively loud sound pressure levels and/or to protect your loudspeakers against overload.

25

Image 25

Lyngdorf Audio DPA-1 owner manual Volume, Def. Vol, Max. Vol

Contents

DPA-1 Page Table of Contents Unpacking the DPA-1 Operating VoltageSerial Number Registration Introduction Accessories Controls Front Panel Rear Panel Display IndicatorsPage Remote Control Page Connecting to sources and ampliﬁers Connecting the DPA-1 Using Main and Line outputs Navigating the Menu System Menu System This is an overview of the entire DPA-1 menu structure Menu Tree Global Listening Introduction to RoomPerfectFocus Listening Voicing RoomPerfect Guided Setup Setting the Measurement Volume Level Room Measurements Focus Measurement Adding more Room Measurements Calculation of Focus 1 and Global Filters Measure Focus Pos Advanced OptionsMeasure Room Pos RoomCorrection RoomKnowledge Volume Disp. Timeo Display TimeoutDisplay Disp. Brightness Def. Vol VolumeMax. Vol Input Sensitivity Input Name Advanced Setup Main Out Control Main OutMain Out Level Line Out Crossover Frequency Routing Filter Type Delay Remote Control Trigger SetupFactory Reset Firmware Versions RoomPerfect Troubleshooting Firmware Upgrading Cleaning and Maintenance Connectors Audio Technical Speciﬁcations Mains ProtectionTrigger Mechanical Technical Assistance Voicing Curves Appendix