Accessories | Lyngdorf Audio DPA-1 instruction

Accessories

You should ﬁnd the following accessories included:

Mains cord	8 m (26.25 feet)
	XLR – XLR cable

Microphone

Programming cable

Remote control	Microphone stand with Mic clamp
	(delivered in a separate carton)

6

Image 6

Lyngdorf Audio DPA-1 owner manual Accessories

Contents

DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Front Panel Controls Display Indicators Rear PanelPage Remote Control Page Connecting the DPA-1 Connecting to sources and ampliﬁers Using Main and Line outputs Menu System Navigating the Menu System Menu Tree This is an overview of the entire DPA-1 menu structure Focus Listening Introduction to RoomPerfectGlobal Listening Voicing Guided Setup RoomPerfect Setting the Measurement Volume Level Focus Measurement Room Measurements Adding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomKnowledge RoomCorrection Display Display TimeoutVolume Disp. Timeo Disp. Brightness Volume Def. VolMax. Vol Input Name Input Sensitivity Advanced Setup Main Out Level Main OutMain Out Control Line Out Routing Crossover Frequency Delay Filter Type Factory Reset Trigger SetupRemote Control Firmware Versions RoomPerfect Troubleshooting Firmware Upgrading Connectors Cleaning and Maintenance Technical Speciﬁcations Audio Trigger ProtectionMains Mechanical Technical Assistance Appendix Voicing Curves