Firmware Upgrading | Lyngdorf Audio DPA-1 specs

Firmware Upgrading

The DPA-1 ﬁrmware can be upgraded using the ‘Lyngdorf Audio – Serial Load’ software. This is in the PC package available from www.Lyngdorf.com.

Follow the upgrade steps shown below to bring the product into upgrade mode.

33

Image 33

Lyngdorf Audio DPA-1 owner manual Firmware Upgrading

Contents

DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Controls Front Panel Rear Panel Display IndicatorsPage Remote Control Page Connecting to sources and ampliﬁers Connecting the DPA-1 Using Main and Line outputs Navigating the Menu System Menu System This is an overview of the entire DPA-1 menu structure Menu Tree Global Listening Introduction to RoomPerfectFocus Listening Voicing RoomPerfect Guided Setup Setting the Measurement Volume Level Room Measurements Focus Measurement Adding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomCorrection RoomKnowledge Volume Disp. Timeo Display TimeoutDisplay Disp. Brightness Volume Def. VolMax. Vol Input Sensitivity Input Name Advanced Setup Main Out Control Main OutMain Out Level Line Out Crossover Frequency Routing Filter Type Delay Remote Control Trigger SetupFactory Reset Firmware Versions RoomPerfect Troubleshooting Firmware Upgrading Cleaning and Maintenance Connectors Audio Technical Speciﬁcations Mains ProtectionTrigger Mechanical Technical Assistance Voicing Curves Appendix