Madrigal Imaging Audio/Video Preamplifier manual Sub On/Off

Programming PAV Functions

If you inadvertantly overwrite one or more PAV commands in your PAV remote control, never fear—you don’t have to obtain another PAV remote in order to re- teach your own its PAV-specific commands. The PAV itself can send all of the nec- essary IR commands from its main display window, enabling you to teach the PAV remote both its pre-programmed commands and a few other, optional com- mands which you might find useful.

When using the PAV itself to teach new commands to your remote control, your remote will have to be in its learning mode (obviously). Therefore, you must navigate the on screen menus by using the buttons on the front panel of the PAV. The buttons on the front panel you need to use are as follows:

•recall: the menu function is provided by the recall button. In order to activate the on screen menus rather than simply recalling the calibrated output level settings, press and hold the recall button un- til the front panel lights are turned off (about ten seconds). From this point on until you exit the menu system, the recall button will perform exactly as the menu button on the remote control would.

•master: the front panel master button is also conveniently placed adjacent to the volume +/– buttons, and serves the same purpose as the one on the remote control.

•volume +/–: the front panel volume +/– buttons also operate in the same fashion as their counterparts on the remote control.

•standby: the enter function is provided by the standby button on the front panel (when the PAV is in menu mode). It is deliberately set apart from all of the other menu-related buttons to make per- manent changes of system parameters a deliberate act.

TEACH REMOTE

PANEL

BUTTONS

REMOTE

ONLY

DIRECT ACCESS

SPECIAL

PRESS

BUTTON

MENU

ENTER

DISPLAY

ON SCREEN

SURROUND

PATH

MISC

CONTROL

REMOTE TRIG ON

REMOTE

TRIG OFF

RE-EQ

ON/OFF

DIRECT

VOLUME

1ENTER THE SETUP MENU

2SELECT “REMOTE CONTROL,” AND THEN “TEACH REMOTE”

3TO RE-LEARN THOSE FUNCTIONS WHICH HAVE CORRESPONDING FRONT PANEL BUTTONS, CHOOSE “PANEL BUTTONS”

The on screen display will prompt you to press any button. Line up the IR window of the PAV remote control with the center of the main display of the PAV, at a distance of approximately 6"-12". Select the to-be-learned but- ton on the remote, then press the corresponding button on the PAV. Notice that a yellow LED in the main display lights up briefly after you press a button. This LED indicates that the PAV is transmitting the command which corresponds to the button you just pushed. You may repeat this process until all buttons have been learned.

Tip: save the teaching of the recall button for last, since its function as the menu button’s “double” will result in the on screen display reverting to the previous menu after it transmits its signal.

4TO RE-LEARN BUTTONS WHICH EXIST ONLY ON THE REMOTE CONTROL, CHOOSE “REMOTE ONLY”

From the teach remote menu, select remote only. The on screen display will now look something like this (see next page):

SUB ON/OFF

54