Marantz SR5007 Troubleshooting

Troubleshooting

If a problem should arise, first check the following:

1.Are the connections correct?

2.Is the set being operated as described in the owner’s manual?

3.Are the other devices operating properly?

If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.

In this case, disconnect the power immediately and contact your store of purchase.

GGeneralH

Symptom	Cause/Solution	Page
Power does not turn	• Check whether the power plug is correctly inserted into the power	34
on.	outlet.
	• The protection circuit is active. Disconnect the power plug from	148
	the electric outlet, wait 5 to 10 seconds and then insert it back
	into the outlet.
Power automatically	• The sleep timer is set. Turn on the power again, or change the	92, 99
switches to standby	sleep timer settings.
mode.	• “Auto Standby” is triggered when there is no operation for a set	130
	amount of time. To disable “Auto Standby”, set “Auto Standby”
	on the menu to “Off”.
Display is off.	• Set “Display” on the menu to something other than “Off”.	130
The STANDBY	• Due to the temperature rise within this unit, the protection circuit	–
indicator is blinking	is working. Please turn off power once, and re-apply the power
red in intervals of	after the temperature has fallen sufficiently.
approximately 2	• Please re-install this unit in a place having good ventilation.	–
seconds.
The STANDBY	• Please use speakers which have the specified impedance.	79
indicator is blinking	• The protection circuit has been activated because the speaker	79
red in intervals of	cable core wires are touching, a core wire has come loose from
approximately 0.5	the terminal, or a core wire is touching the rear panel of this unit.
seconds.	After unplugging the power cord, take corrective action such as
	firmly re-twisting the core wire or taking care of the terminal, and
	then reconnect the wire.
After turning on	• This unit amplifier circuit has failed. Turn off the power and please	–
the power, the	contact the marantz service adviser.
STANDBY indicator
is blinking red
in intervals of
approximately 0.5
seconds.
Set does not operate	• Reset the microprocessor.	154
properly.

GHDMIH

Symptom	Cause/Solution	Page
No audio is	• Check the connection of the HDMI connectors.	10
output with HDMI	• When outputting HDMI audio from the speakers, set “HDMI	112
connection.	Audio Out” on the menu to “AVR”.
	• When outputting HDMI audio from a TV, set “HDMI Audio Out”	112
	on the menu to “TV”.
No video is	• Check the connection of the HDMI connectors.	10
output with HDMI	• Set the input source to match the connected HDMI connector.	10, 34
connection.	• Check whether the TV is compatible with copyright protection	11
	(HDCP). If connected to a device not compatible with HDCP, video
	will not be output correctly.
When the following	• Set “HDMI Control” in the menu to “Off”.	91, 112
operations are	Furthermore, if you do not want to link the power off operation
performed on	with devices compatible with HDMI control, set “Power Off
devices compatible	Control” in the menu to “Off”.
with HDMI control,
the same operations
occur on this unit.
• Power ON/OFF
• Switching audio
output devices
• Adjust volume
• Switch input source
GVideoH
Symptom	Cause/Solution	Page
No picture appears.	• Check the connection between the video output terminal of this	9, 13
	unit and the input terminal of the TV.
	• Match the input settings to the input terminal of the TV connected	–
	to this unit.

version Basic

version Advanced

Information

DVD 150