Set up speakers | around items indicate the settings. |
First install and connect the speakers to this unit.
Before Audyssey® Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK speaker terminal of this unit can be switched to match your speaker environment (vpage 87 “Set up “Amp Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 88 “Set up “Channel Select””).
version Basic
1 | Set up the | 2 | Connect the setup microphone. |
| |||
remote control unit |
| ||
|
|
|
3 | Set up “Amp Assign” |
Use ui to select “Amp Assign”, and then press
Advanced
nn Set up the zone mode
Press MAIN to switch the zone mode to the MAIN ZONE.
MAIN lights.
Press MAIN
When the setup microphone is connected, the following screen is displayed.
ENTER.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
Start
version
Information
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
Start
Amp Assign |
|
Assign Mode | Surround Back |
ZONE2: 
Selects how to use the internal amplifiers
4 Select “Assign Mode”, and then press ENTER.
v See overleaf
DVD | 87 |