ENGLISH
REAR PANEL
z x | c | v b n |
|
|
| ANTENNA |
|
|
| COMPONENT VIDEO |
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| DVD |
|
| DSS/VCR2 |
| MONI.OUT |
|
|
|
|
| |
|
|
|
|
|
| Y | CB/PB | CR/PR | Y | CB/PB | CR/PR | Y | CB/PB | CR/PR |
|
|
|
|
FM (75Ω) | GND | AM |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
VIDEO |
|
|
|
|
|
|
|
|
| VCR1 | DSS/VCR2 |
|
|
|
| |||
TV | DVD |
| VCR1 | DSS/VCR2 | MONI. |
|
|
|
|
|
|
|
|
| ||||
| TV | DVD | IN | OUT | IN | OUT | MONI.OUT |
|
|
|
| |||||||
|
| IN | OUT | IN | OUT | OUT |
|
|
|
|
|
|
|
|
|
|
|
|
|
| DIGITAL IN |
|
| DIGITAL OUT |
|
|
|
|
|
|
|
|
|
| |||
|
|
|
| IN | L | SL | C | PRE |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
1 | 2 | 3 | 4 | 5 | 6 | OPT. | COAX. |
|
|
|
| OUT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| OUT | R | SR | SB | SW |
|
|
|
|
|
|
TV | DVD |
| VCR1 | DSS/VCR2 | CD | TAPE | CDR/MD | L | SL | C |
| R | L | R | L | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
| 6.1CH | ||||
L |
|
|
|
|
|
|
|
|
|
|
|
|
| IN |
|
|
|
|
R |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
m,
AC IN
SERIAL NO.
SWITCHED UNSWITCHED 1A 120W MAX 1A 120W MAX
AC OUTLETS
120V 60HZ
RL
bMONITOR OUT
This is a monitor output and each one includes both composite video and
nRS232C
The RS232C port is to be used in conjunction with an external controller to control the operation of the SR6400 by using an external device.
mPower cable
Connect to an AC power outlet.
SR6400 has to be powered by 120 V AC only.
,AC OUTLETS
⁄0Subwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an external subwoofer amplifier is used, connect this jack to the subwoofer amplifier input. If you are using two subwoofers, either powered or with
a2 channel subwoofer amplifier, connect a “Y” connector to the subwoofer output jack and run one cable from it to each subwoofer amplifier.
⁄16.1 CHANNEL INPUT
By connecting a DVD Audio player, SACD multichannel player, or other components that has a multichannel port, you can playback the audio with 5.1 channel or 6.1 channel outputs.
⁄2REMOTE CONT. IN/OUT terminals
Connect to a Marantz component equipped with remote control
|
|
|
|
|
|
|
|
|
|
|
| FRONT A | FRONT B | CENTER | SURROUND | SURROUND |
IN | OUT | IN | OUT | IN | OUT | IN | OUT | R | SR | SB | SW |
|
|
|
| BACK |
SPEAKER SYSTEMS |
|
|
|
| ||||||||||||
|
|
|
| AUDIO |
|
|
|
|
|
|
| FRONT A OR B, CENTER, SURROUND, SURR. BACK : MINIMUM 6 OHMS |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| FRONT A AND B : MINIMUM 8 OHMS |
|
|
| |
⁄4 ⁄3 | ⁄2 ⁄1 ⁄0 | . |
Connect the AC power cables of components such as a DVD and CD player to these outlets. SWITCHED and UNSWITCHED outlets are provided.
The one marked SWITCHED provides power only when the SR6400 is turned on and is useful for components which you use every time you play your system.
⁄3AUDIO IN/OUT (CD, TAPE,
DVD, VCR1, DSS/VCR2)
These are the analog audio inputs and outputs. There are 7 audio inputs (4 of which are linked to video inputs) and 4 audio outputs (2 of which are linked to
zVIDEO IN/OUT (TV, DVD, VCR1, DSS/VCR2) These are the video inputs and outputs. There are 4 video inputs and 2 video outputs and each one includes both composite video and
The 2 video output channels can be used to be connected to video tape recorders for making recordings.
xFM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or a cable network FM source.
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception.
cCOMPONENT VIDEO INPUT/OUTPUT
If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the SR6400. The SR6400 has two component video input connectors to obtain the color information (Y, CB, CR) directly from the recorded DVD signal or other video component and one component video output connector to output it directly into the matrix decoder of the display device.
By sending the pure DVD component video signal directly, the DVD signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly life like colors and crisp detail.
Notes:
•This component video output will not display the OSD menu system.
v Preamp Outputs (L, R, SL, SR, SB, C) Jacks for L(front left), R (front right), C (Center), SL (surround left), SR (surround right) and SB (surround back).
Use these jacks for connection to external power amplifiers.
The one marked UNSWITCHED is always live as long as the SR6400 is plugged into a live outlet. A component connected here may be left on permanently, or may be switched off with via its own power switch.
Caution:
•In order to avoid potential
•The capacity of this AC outlet is 120W. Do not connect devices that consume electricity more than the capacity of these AC outlets. If the total power consumption of the connected devices exceeds the capacity, the protection circuit shuts down the power supply.
.Speaker outputs terminals
Eight terminals are provided for the front (A) left, front (A) right, front (B) left, front (B) right, front center, surround left, surround right and surround back speakers.
video outputs). The audio jacks are nominally labeled for cassette tape decks, compact disc players, DVD players and etc.... The audio inputs and outputs
require
⁄4DIGITAL INPUT (Dig.1 - 6) / OUTPUT (coaxial, optical)
These are the digital audio inputs and outputs. There are 3 digital inputs with coaxial jacks, 3 with optical jacks.
The inputs accept digital audio signals from a compact disc, LD, DVD, or other digital source component.
For digital output, there is 1 coaxial output and 1 optical output.
The digital outputs can be connected to MD recorders, CD recorders, DAT decks, or other similar components.
6
