Marantz SR9200 manual English, Preference, Bass Peak Level

ENGLISH

BASS PEAK LEVEL

With Dolby Digital and DTS , not only the LFE (Low Frequency Effects), but also the bass of all channels can be heard from the Subwoofer or Large-speakers. This procedure prevents these speakers from becoming too loud and creating an unbalanced sound. Since the sound is output at a loud volume, perform this operation carefully.

Note:

•If your system does not include a subwoofer, this setting will set the bass peak level for your front speakers.

2 - 4 BA S S P E AK L E V E L

BA S S P E AK T E S T : S T AR T

VO L UME L E V E L	:	+ 1 8 d B
- - - - - - - - - - - - - - -		- - - - -
		E N T E R
MA I N R E T URN		E X I T

TEST SIGNAL: Press the OK or Left button, START is indicated and it begins to generate a Bass test tone from the speaker which was designated “bass signal output” during setup.

There will be no audible sound yet because the Master volume is set to minimum automatically. Press Down cursor button to move the cursor to VOLUME control.

VOLUME: Adjust the bass test tone output level up until the bass begins to distort or you reach the maximum level with the VOL+, VOL– or Right / Left cursor button.

Press Down cursor button to move the cursor to

ENTER.

ENTER: Press the OK button, ENTER will blink and stop generating the Bass Peak test tone.

The Bass Peak Limit Level for your system has now been memorized.

If you finish these setup, move cursor to “MAIN” with Up or Down cursor button and then press OK button to go to MAIN menu.

Notes:

•Each time the subwoofer level is changed, perform the Bass Peak Level setup and correct the setting.

•The bass peak level is not available in SOURCE-DIRECT and 7.1CH-INPUT mode.

•The selected value is displayed in the volume column before the test signal starts.

PREFERENCE

3 P R E F E R E NC E
T V - AU T O	: D I S AB L E
O S D I N F O	:	E NAB L E
D I G I T A L OU T	: S OURC E
S UBWOOF E R OU T	:	T H X
MA I N		E X I T

1. Select “PREFERENCE” in MAIN SETUP MENU with Up or Down cursor button, and press the OK button.

2. To select a desired content, press Up or Down cursor button.

TV AUTO: Select the TV AUTO ON/OFF function to enable or disable with Left or Right cursor button.

(refer to page 39)

OSD Info: Select the OSD information function to enable or disable with Left or Right cursor button.

If you select “ENABLE”, SR9200 will display the status of the feature (Volume up/down, input select, etc..) on the TV monitor. But if you do not desire this information, select “DISABLE “.

DIG. OUT: Select the digital source to output the DIGITAL OUT

terminals with Left or Right cursor button.

This is for digital dubbing to a CD-R recorder or MD deck. (See page 45)

The source is switched in the following sequence. SOURCE →DIG.1 →DIG.2 → → →DIG.8 →DIG.9 → AUX →OFF →SOURCE →

SUB-W OUT: “THX” position is required, but If you desire an additional front L/R mixed subwoofer output in the STEREO mode, select “L/R MIX” with Left or Right button.

If you finish the setup in this item, move cursor to “MAIN” with Up or Down cursor buttons and press OK button.

30