Adding Rubber Feet to Your
Maxtor OneTouch II Drive
If you plan to use your drive on a desk surface, your kit includes four rubber feet to protect your drive and the surface of your desk.
To apply the feet:
1.Make sure your drive is disconnected properly from your computer. (“Connecting and Disconnecting the Drive” on page 27).
2.Make sure your drive is turned off, by turning off the power switch on the back of the drive.
3.Turn your drive so that the ridges are facing up. This is the bottom of the drive.
4.Place two rubber feet on each ridge on the bottom of your drive. One should be placed near the front and the other toward the back of each ridge.
Bottom of Drive
Rubber Feet
Placement
Figure 15. Adding Rubber Feet to Your Drive
3
Using Your Drive
51
