Maytag MMV51566AA/MMV5156AC Maintenance, Care And Cleaning, Cleaning The Grease Filter

Models: MMV51566AA/MMV5156AC

1 84
Download 84 pages 22.59 Kb
Page 23
Image 23
Maintenance

Maintenance

CARE AND CLEANING

For best performance and safety, keep the oven clean inside and out- side. Take special care to keep the inner door panel and the oven front frame free of food or grease build-up.

Never use rough powder or pads. Wipe the microwave oven inside and out, including the hood bottom cover, with a soft cloth and a warm (not hot) mild detergent solution. Then rinse and wipe dry. Use a chrome cleaner and polish on chrome, metal and aluminum surfaces. Wipe spatters immediately with a wet paper towel, especially after cooking chicken or bacon. Clean your oven weekly or more often, if needed.

3.To reinstall the filter, slide it into the side slot, then push up and toward oven center to lock.

CARE AND CLEANINGCAUTION

To avoid risk of personal injury or property damage, do not operate oven hood without filters in place.

4.Open the door.

5.Push the hook and remove old filter.

Hook

6.Slide a new charcoal filter into place and close the door. The fil- ter should rest at the angle shown.

CLEANING THE

GREASE FILTER

The grease filter should be removed and cleaned often, at least once a month.

1.To remove grease filter, slide filter to the side. Pull filter down- ward and push to the other side. The filter will drop out.

2.Soak grease filter in hot water and a mild detergent. Rinse well and shake to dry. Do not use ammonia or place in a dish- washer. The aluminum will darken.

CHARCOAL FILTER REPLACEMENT

If your oven is vented inside, the char- coal filter should be replaced every 6 to 12 months, and more often if nec- essary. The charcoal filter cannot be cleaned. To order a new charcoal fil- ter, contact the Parts Department at your nearest Authorized Service Center or call 1-800-688-9900(USA) or 1-800-688-2002(Canada). Order Charcoal Filter kit #: MVHRK4.

1.Unplug oven or turn off power at the main power supply.

2.Remove the two vent grille mounting screws. (2 screws)

3.Tip the grille forward, then lift it out.

7.Slide the bottom of the vent cover into place. Push the top until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply and set the clock.

23

Page 23
Image 23
Maytag MMV51566AA/MMV5156AC Maintenance, Care And Cleaning, Cleaning The Grease Filter, Charcoal Filter Replacement