BLADE
To remove the blade (23) unscrew the screw (24).
Check the conditions of the
When reassembling, make sure that the key (27) is cor- rectly seated in the shaft and that the cutting edges face in the direction of the engine rotation. The blade screw (24) must be torqued to 5,34 Kgm (52,4 Nm)..
VERSION WITH BLADE BRAKE
To remove the blade (29) unscrew the two screws (30).
Check the condition of the blade and replace any parts that are damaged,
KIT ELECTRIC STARTING
Before starting the motor for the first time, you are advised to keep the battery on charge for 2
to 3 hours.
If the battery proves to be low during starting, charge it for 24 hours.
When starting, don’t keep trying to start for more than 5 seconds.
BATTERY DISPOSAL
Those batteries marked with a “crossed out waste disposal bin” and bearing the chemical symbol Pb (battery containing lead) are not to be disposed in domestic waste bins.
BATTERY MAINTENANCE
IMPORTANT
For correct battery maintenance (31), especially in prepa- ration for a long period of inactivity, and for recharging, it is not necessary to remove it from its casing, but to simply proceed as follows:
1)Remove contact (32).
2)Store the battery in a fresh and dry place.
3)Recharge the battery before use at room temperature for
4)Restore the contact (32) before use
Pb |
The user is legally obliged to take the used batteries to special collection points or to return them to the retailer.
Guarantee and Guarantee Policy
If any part is found to be defective due to faulty manufacture within the guarantee period, Husqvarna AB, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing:
a)The fault is reported directly to the Authorised Re- pairer.
b)Proof of purchase is provided.
c)The fault is not caused by misuse, neglect or faulty adjustment by the user.
d)The failure has not occurred through fair wear and tear.
e)The machine has not been serviced or repaired, taken apart or tampered with by any person not authorised by Husqvarna AB.
f)The machine has not been used for hire.
g)The machine is owned by the original purchaser.
h)The machine has not been used commercially.
This guarantee is additional to, and in no way diminishes the customers statutory rights.
Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator’s Manual and understand how to operate and maintain your machine:
Failures not covered by guarantee
-Replacing worn or damaged blades
-Failures as a result of not reporting an initial fault.
-Failures as a result of sudden impact.
-Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator’s Manual.
-Machines used for hire are not covered by this gua- rantee.
-The following items listed are considered as wearing par- ts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty
claim: Blades, Electric Mains cable, Belt
Caution!
Husqvarna AB does not accept liability under the war- ranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by
Husqvarna AB, or by the machine having been modified in any way.
