Rear & Right Side
D | E F | G | H |
SCREEN TRIGGER | SERVICE | DVI |
B
Removing the control panel cover
Release | C |
| |
Lock | A |
| |
A Control Panel Cover | E Screen Trigger socket |
Remove this cover when operating this unit or | This socket is used for controlling a motorised |
when replacing the lamp unit. | screen. An output at DC +12 V/100 mA (max.) |
• Unlock the cover, followed by sliding it down- | is produced when the power is on. |
wards to remove it. | • Consult a qualified technician for a connection |
• Please refer to page 11 for details on the con- | with the screen. |
trol panel. |
|
Handling the Control Panel Cover
•The gap between the body of the unit and the control panel cover is narrow. Be careful not to stick your finger into the gap between the body of the unit and the control panel cover.
•After attaching the control panel cover, check that the lock is fastened securely.
B Exhaust Vent
Warm air is expelled through this vent to keep the system cool. Do not block the exhaust vents as this may cause the unit to overheat and fail.
C AC Power Input Socket
This is the AC power input socket. Connect the supplied power cable to this socket.
D Remote Sensor (Rear)
When operating with the remote control, aim it towards the sensor. (Page 14)
•A remote sensor is also located at the front of the unit.
F Service Connector
This connector is intended for servicing pur- poses and should not normally be used.
G
•For details, please check with your authorized dealer.
H DVI input (DVI-D 24 Pin)
This is the input socket for video signals. 1080/50p and 1080/60p signals are supported and HDCP content protection capability is provided.
10
