
3.2.Code 39
This is the most popular
3.2.1.Standard/Full ASCII
The Code 39 Full ASCII option allows the transmission of the 128 ASCII characters. Each ASCII character is a combination of two Code 39 characters. It can be very useful specially to transmit control characters (STX, ETX, TAB, EOT…) as preambles or postambles in a message (see appendix 6.3, page 58). The Code 39 Full ASCII Table is listed in appendix 6.10, page 70.
STANDARD *
FULL ASCII
3.2.2.Full ASCII Extended
In
The function key to be emulated is represented by two Code 39 characters from the Code 39 Full ASCII Extended Table (see appendix 6.8, page 65), which can be part of the symbol or separate from it.
DISACTIVATED *
ACTIVE ON TWO CHARACTERS
PRECEDED BY A DASH
(part of or separate from the symbol)
ACTIVE ON TWO CHARACTERS | ACTIVE ONLY ON TWO CHARACTERS |
(part of or separate from the symbol) | SEPARATE FROM THE SYMBOL |
!Note:
The function key value to be emulated can be set as a preamble or a postamble of message (see appendix 6.3, page 58).
START OF CONFIGURATION | END OF CONFIGURATION |
|
|
IS1000 – Configuration Guide | 24 |