3.14.IATA

This code is used by the airline and railway companies and are printed at the bottom of each ticket. It is in fact a Standard 2/5 code with 2 bar start/stop characters.

Once activated (see Symbology Selection, chapter 3.1), only codes with 15, 17, 19 or 21 characters can be decoded.

3.15.BC 412

This symbology has been developed by IBM and is reserved for IBM and authorized companies only. To decode it the decoder must be equipped with specific firmware available on request, accompanied with an authorization letter from IBM.

It uses a check digit being the second character in the code which is verified and transmitted or not depending of the option selected.

CHECK DIGIT NOT TRANSMITTED *

CHECK DIGIT TRANSMITTED

3.16.3W7

Mainly used in Italy, this symbology has a set of 28 characters (numeric, letters A to F, a few symbols and ASCII control characters).

A check digit modulo 28 is used as the last character in the code which is always verified but not transmitted.

START OF CONFIGURATION

END OF CONFIGURATION

 

 

IS1000 – Configuration Guide

43

Page 51
Image 51
Metrologic Instruments IS1000 manual Iata, 15. BC, 16 W7