13
CRADLE INSTALLATION TO THE HOST DEVICE
Full Speed USB (Powered by External Power Supply)
1. Turn off the host device.
2. Connect the 10-pin RJ45 male
connector into the 10-pin
modular jack on the bottom of
the charger cradle.
3. Connect the USB A type
connector to the USB port on
the host device.
4. Plug the power supply into the
power jack on the bottom of the
cradle.
Check the AC input
requirements of the
power supply to make
sure the voltage matches
the AC outlet. The outlet
must be located near the
requirement and be
easily accessible.
5. Plug the power supply into the AC outlet.
The blue LED on the rear of the cradle will stay on.
6. Turn on the host device.
7. Establish communication between the scanner and cradle. See page
15 for complete instructions on Establishing Bluetooth Communication
between the scanner and cradle.
The scanner must be charged for a minimum of 3 hours before the
scanner can be placed in full operation for the first time. After the initial
preparation charge of 3 hrs, the battery will only require 2.5 hrs to come
to a full charge when it gives a Low Power warning (see page 18).
See page 6.
Figure 9. Full Speed USB