Meyer 3216, 4218, 4220, 3220, 4216, 3218, 4222 manual Pre-Operationtransporting, 3200 & 4200 Series

Models: 4220 3218 4216 Front and Rear Unload Forage Boxes with Indpendent Outfeed Clutch 3220 4222 3216 4218

1 68
Download 68 pages 43.77 Kb
Page 11
Image 11
PRE-OPERATIONTRANSPORTING

PRE-OPERATIONTRANSPORTING

Be certain your forage box is properly mounted to the running gear. Consult your dealer if you have any ques- tions about the tie down kit from the manufacturer and il- lustrated in the parts listing of this manual.

DO NOT fill the cross conveyor unloading area with for- age to get extra capacity. Overloading puts unnecessary pressures and strains on the cross conveyor and auger drive.

This forage box is to be operated with 540 rpm PTO ONLY. Set your tractor drawbar to conform to the stan- dard dimensions as shown on the following illustration. This will ensure that the PTO drive shaft will not be over extended.

Always disconnect the PTO drive shaft from the tractor and return it to the PTO storage bracket on the unloading unit before transporting. Failure to do this may result in equipment damage.

If you have a fold down cross conveyor extension, al- ways transport with this extension folded up to reduce your width. Check and observe that the rear discharge door is completely latched closed before traveling on roadways.

FOLD DOWN CROSS CONVEYOR EXTENSION

DRAWBAR & PTO RELATIONSHIP

DANGER: DO NOT OPERATE WITHOUT PTO GUARD ON MACHINE AND ON TRACTOR. MAINTAIN PTO DRIVE SHAFT GUARDS IN OPERATING CONDI- TION. REPLACE THEM IF DAMAGED AND NOT TURNING FREELY. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

WARNING: INSPECT REGULARLY THAT ALL CONNECTIONS AND BOLTS ARE TIGHT AND SE- CURE BEFORE OPERATING. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

Inspect the forage box for proper adjustments as this will ensure maximum machine performance. See “Adjust- ments” section. Grease and oil the forage box as re- quired. See “Lubrication” section.

WARNING: DO NOT OPERATE UNTIL ALL SHIELDS AND GUARDS ARE IN PLACE AND SE- CURELY FASTENED. FAILURE TO HEED MAY RE- SULT IN SERIOUS PERSONAL INJURY OR DEATH.

WARNING: INSTALL A SMV EMBLEM ON REAR OF FORAGE BOX FOR TRANSPORTING ON ROADWAYS. KEEP THIS EMBLEM CLEAN AND BRIGHT. FAILURE TO HEED MAY RESULT IN SERI- OUS PERSONAL INJURY OR DEATH.

3200 & 4200 Series

-- 9 –

Page 11
Image 11
Meyer 3216, 4218, 4220, 3220, 4216, 3218, 4222 manual Pre-Operationtransporting, 3200 & 4200 Series