Meyer 3218 Front Unload Drive Coupler “Set-Up”, Pto Or Hydraulic Drive, Truck Mount Forage Boxes

Truck Mount Forage Boxes

Depending on the make and model of truck it may be necessary to install a light converter (MEYER PART #56-0028.) Converter will allow signal lights and brake lights to operate according to DOT lighting standard. Call factory for more information.

FRONT UNLOAD DRIVE COUPLER “SET-UP”

(PTO OR HYDRAULIC DRIVE)

WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC PRES- SURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS FORAGE BOX. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

STEP 1

Install Coupling Plate and lynch pin onto the large gear- box assembly, splined shaft at the FRONT of the forage box.

(Shield Removed For Illustration Purposes Only)

COUPLING PLATE

QUILL

ZERK

(Shield Removed For Illustration Purposes Only)

SLEEVE SPACER

STEP 2

IMPORTANT! (MUST PERFORM)

Install sleeve spacer and lynch pin onto the hydraulic drive gearbox at the REAR of the forage box. The internal splined shaft will be idling in reverse and the gearbox quill zerk must be greased daily.

WARNING: DO NOT OPERATE WITHOUT ALL SHIELDS, GUARDS AND COVERS INSTALLED. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

3200 & 4200 Series -- 11 –