Meyer Front and Rear Unload Forage Boxes with Indpendent Outfeed Clutch, 4218 tion Purposes Only

INDEPENDENT OUTFEED CLUTCH BELT RE- PLACEMENT

1.Move the Independent Outfeed Clutch control lever to “STOP” (up).

2.Extend the PTO drive shaft out straight and lower the tractor end down to ground level.

3.Unlatch and raise the hinged top, front chain shield assembly.

4.Remove the clutch bottom bracket - “belt pan.”

5.Roll off the old Double V-Belt from the two pulleys.

6.Slide off the old belt down the length and over the end of the PTO drive shaft.

7.Install new Double V-Belt onto the two pulleys and check for proper engage, “RUN” tension. Adjust as needed.

8.Refasten the clutch bottom bracket - “belt pan and the PTO input shaft cover.‘

9.Lower and latch close the hinged top, front chain shield assembly.

10.Raise PTO drive shaft from ground level and return it to the PTO storage bracket.

INDEPENDENT OUTFEED CLUTCH ADJUSTMENT

Lengthen or shorten linkage bolt with jam nut to create moderate tension on the Double V-Belt when engaging the Independent Outfeed Clutch control lever into the “Run” position.

INDEPENDENT OUTFEED CLUTCH ADJUSTMENT

INDEPENDENT OUTFEED CLUTCH (Shield Removed for Illustra-

tion Purposes Only)

3200 & 4200 Series -- 29 --