Meyer 4220, 4218, 3220, 3216, 4216 Outfeed Clutch, Forage Box Control Levers, 15, 3200 & 4200 Series

FRONT UNLOAD VARIABLE SPEED OPERATION WITH INDEPENDENT

OUTFEED CLUTCH

DECAL #46-0001-64

FORAGE BOX CONTROL LEVERS

WARNING: NEITHER THE VARIABLE SPEED NOR THE HI-LO RANGE CONTROL LEVER WILL DIS- ENGAGE THE CROSS CONVEYOR. ONLY THE TRAC- TOR PTO, INDEPENDENT OUTFEED CLUTCH, OR EMERGENCY STOP MECHANISM WILL STOP THE CROSS CONVEYOR . FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

Facing the front of the forage box, the lower most RH control lever is the INDEPENDENT OUTFEED CLUTCH control. Moving this control lever down into the “Run” po- sition engages the cross conveyor and main drive mech- anism. Engage this control lever into the “Run” position for normal operation. Once this control lever is engaged, it acts as the emergency stop when pushing on the “Warning Push for Emergency Stop” push bar or when pulling on the emergency stop trip cables.

The LH control lever is the VARIABLE SPEED control. Moving this control lever regulates rotational speed of the unloading augers and the forward speed of the main apron chains, in conjunction with the HI-LO RANGE con- trol. At the uppermost notch on the control quadrant, the VARIABLE SPEED control is in “Neutral” position. In this position, neither the main apron chains advance, nor do the unloading augers rotate under load, regardless of the position of the HI-LO RANGE control. Moving the VARI- ABLE SPEED control lever down on the control quadrant increases speed of both auger rotation and main apron chain forward travel.

The RH control lever is the HI-LO RANGE control. Cen- ter detent is the “Neutral” position. Shifting the lever up on the control quadrant is “LO” RANGE and shifting the lever fully down is “HI” RANGE. Range selection affects the forward speed of the main apron chains only. In the “Neutral” position, the main apron chain does not travel forward.

HI-LO RANGE

VARIABLECONTROL

SPEEDLEVER

CONTROL

LEVER

IOC CONTROL

LEVER

Three levers control operating the front unloading unit of the forage box.

1.INDEPENDENT OUTFEED CLUTCH - IOC

2.VARIABLE SPEED

3.“HI-LO RANGE”

3200 & 4200 Series -- 15 –