Programming special functions
For future servicing work, please document any alterations to the stan- dard factory settings.
Enter any alterations in the relevant
Value set:_________ box. | . |
1.Setting the cold water inlet from: Nominal water intake to Nominal wa- ter intake + 1 l.
The amount of water taken into the machine at each intake can be increased by 1 litre to a maximum of
9.5litres.
To do this:
^Turn the programme selector to STOP f.
^Switch the machine off.
^Press and hold 4 and 6 at the same time, and whilst doing so switch the machine on with the
The current programme status “P...” appears in the display and the p / 6 indicator lights up.
^Press 3 once. E01 for programming level 1 will appear in the display.
^Turn the programme selector to the D position. A 10 or an 11 will appear in the display.
10 = Nominal water intake
11 = Nominal water intake + 1 l
^Press 4 to change from 10 to 11 or vice versa.
^Press 6. SP appears.
^Press 6 again. The change has been recorded.
Value set:
2. Selecting a second interim rinse
Interim Rinse II can be programmed in to improve interim rinsing in all programmes (except D
^Turn the programme selector to STOP f.
^Switch the machine off.
^Press and hold 4 and 6 at the same time, and whilst doing so switch the machine on with the
The current programme status “P...” appears in the display and the p / 6 indicator lights up.
^Press 3 once. E01 for programming level 1 will appear in the display.
^Turn the programme selector to o. A 30 or an 31 will appear in the display. 30 = without Interim rinse II.
31 = with Interim rinse II.
^Press 4 to change from 30 to 31 or vice versa.
^Press 6. SP appears.
^Press 6 again. The change has been recorded.
Value set:
33