Electrical connection
,All electrical work must be carried out by a suitably qualified and competent person in accordance with local and national safety regulations.
^Connection should be made via a suitable isolator, with an
WARNING
THIS APPLIANCE MUST BE
EARTHED
^For extra safety it is advisable to install a residual current device with a trip current of 30 mA (in accordance with DIN VDE 0664).
^The mains connection cable may only be replaced by an original Miele spare part or an apppropriate cable with wire end ferrule.
^For technical data see data plate or wiring diagram supplied.
The machine must only be operated with the voltage, frequency and fusing shown on the data plate.
This machine can be converted in accordance with the conversion diagram and wiring diagram supplied.
The data plate (with test certification VDE, DVGW etc.) and conversion key are located on the rear of the machine and also behind the plinth panel below the protective plastic cover.
The wiring diagram is secured to the inner side of the protective plastic cover.
Removing the plinth panel and the protective plastic cover:
,Disconnect the machine from the mains electricity supply.
^Holding the plinth panel at both sides, pull gently outwards from beneath a and pull it off b.
^To remove the protective plastic cover loosen the 2 screws (left and right) c.
To
^Refit the protective plastic cover and the plinth panel in the reverse order to which they were removed.
See also the installation diagram supplied.
Bonding connection
There is a screw connection point marked with the earth symbol (8) at the back of the machine, to which the earth lead must be connected.
48