| Installation |
Please refer to the installation | ^ Open the door. |
diagram supplied with the machine. |
|
,Furniture and fittings installed |
|
near the machine must be of a |
|
commercial standard able to |
|
withstand the effects of steam and |
|
condensed water. |
|
The machine must be installed correctly |
|
and levelled. |
|
Any unevenness in the floor level can |
|
be compensated for and the height of |
|
the machine raised or lowered by |
|
adjusting the four screw feet. |
|
The machine can be installed in the following ways:
^
^
The machine can be installed next to other machines or furniture or in a suitable niche. The niche must be at least 60 cm wide and 60 cm deep.
^
The machine can be installed under a continuous worktop or sink drainer. The recess must be at least 60 cm wide, 60 cm deep and 82 cm high.
If necessary, the machine lid can be removed as follows:
^Remove the fixing screws on the left and right hand sides using a cross slotted screwdriver.
^Pull the machine lid approx. 5 mm forwards, lift it upwards and remove it.
Important for machines fitted with a steam condenser (depending on mo- del):
To prevent damage by steam to the worktop, the self adhesive protective foil supplied (25 x 58 cm) must be stuck in place underneath the worktop near the steam condenser.
45
